Instalacja i konfiguracja Gude Craftsman 917 293472 jest stosunkowo prosta. Przed rozpoczęciem należy zapoznać się z dołączoną instrukcją obsługi i przestrzegać wszystkich zaleceń dotyczących bezpieczeństwa. Wybierz odpowiednią lokalizację do instalacji i wykonaj wszystkie wytyczne dotyczące przygotowania obszaru. Przygotuj wszystkie niezbędne narzędzia i materiały, takie jak śruby, nakrętki, nity, masywna podstawa, itp. Następnie podłącz do sieci zasilającej i uruchom narzędzie, wykonując wszystkie wymagania dotyczące instalacji. Gdy wszystko jest już gotowe, możesz przejść do konfiguracji narzędzia, takiej jak ustawienia prędkości, momentu obrotowego, itp. Po zakończeniu konfiguracji narzędzie może być gotowe do użycia.
Bezpośredni link do pobrania Instalacja i konfiguracja Gude Craftsman 917 293472
Ostatnia aktualizacja Instalacja i konfiguracja Gude Craftsman 917 293472
Komentarz
Thanks for the video. I have an Atlas tiller that looks very similar to yours. Where did you order your parts?
Working on one that is identical, my water got in through the shifter shaft. There is an O-ring that goes just inside the sleeve from the outside of the gearbox. I noticed that you didn't take yours off and I wondered if you knew that there was an O-ring inside there that needed to be replaced. I replaced the seal on my gearbox and still got water in and rested Out The Chain. So now I've replace the chain but I've also replace the O-ring inside the shifter shaft
I installed “after factory grease fittings”. Thanks for the vid.
I have two of these gear boxes and the same part failed on both. There were no spring and ball that I found. Could you send a picture or send a picture of where it is.
nice vid. Im working on a similar tiller. what kind of grease did you use for replacement?
Where can I get parts in Canada?
Nice videos. Is this the model tiller that tills in forward and reverse; Model # 917299080 ? Mine was stuck in gear as well, but it was the input shaft gears rusted/froze on the input shaft. I'm putting it back together now, but I seem to be missing a spacer, (after it sitting a year) maybe not, A spacer is not shown on the diagram as well. However, seems like there should be a spacer on either side of gear #56 to keep it from sliding back and forth as it can move 2 inches. You have photo's of it all together sans grease?
Does the ball go against the pin? Or the spring? The sketch shows the spring but that doesn't make sense to me...
Where did you get your parts?
U still running it? I just bought one with a new predator 6hp engine on it. I Really want to check my gear box out. Maybe clean it up inside and pack new grease in it
Anymore vids in this?
mine has the same issue
What model# is this?
I have a craftsman tiller that won't pull it self
.